308
Presence and light sensors
RADAR SENSOR ON-OFF Motion detectors have a wide DETECTION range and react to MOVEMENT. The sensor IMMEDIATELY SWITCH...
RADAR SENSOR ON-OFF Motion detectors have a wide DETECTION range and react to MOVEMENT. The sensor IMMEDIATELY SWITCHES ON the connected device whenever it senses movement within its scan area, automatically distinguishing between NIGHT and DAY.
Example of application: parking garage The lighting in an underground parking garage should be triggered by motion, such as a person or a car entering the area.
08 SENSORI.indd 308
28/07/16 16:17
Presence and light sensors
309
GROUP 1
sub-code -19
sub-code -0072
standard fixture
GROUP 2
MICROWAVE ON-OFF (CONTINUOUS LINE)
sub-code -19
sub-code -0072
standard fixture
power cable
MICROWAVE ON-OFF-OFF STAND ALONE
sub-code -19
sub-code -19
sub-code -19
sub-code -19
sub-code -19
sub-code -19 power cable
TEST 1.Turn the LUX knob clockwise on the maximum (sun) 2. Turn the SENS knob clockwise on the maximum (+). 3. Turn the TIME knob anti-clockwise on the minimum (10s). 4.When you switch on the power, the light will be on at once. And 10sec±3sec later the light will be off automatically. Then if the sensor receives induction signal again, it can work normally. 5.When the sensor receives the second induction signals within the first induction, it will restart to time from the moment. 6.Turn LUX knob anti-clockwise on the minimum (3). If the ambient light is less than 3LUX (darkness), the inductor load could work when it receives induction signal.
40
1,5-3,5m max
m
8 1-
360°
x
ma
Note: when testing in daylight, please turn LUX knob to [SUN] position, otherwise the sensor lamp could not work!