Installation Instructions RENNtech 218 CLS 63 AMG Front Splitter

Installation Instructions RENNtech 218 CLS – 63 AMG – Front Splitter ©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - ...
Author: Domenic Simpson
2 downloads 0 Views 5MB Size
Installation Instructions RENNtech 218 CLS – 63 AMG – Front Splitter

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Safety Information!

All of the necessary work must be performed by qualified persons with an appropriate level of expertise only.

Before starting the assembly procedure, carefully read the assembly instructions in full and pay attention to the safety information and sequence of the individual steps.

Switch off the ignition and disconnect the battery when working on the vehicle electrical/electronics systems.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Preparation! Check the part list and ensure that all parts are included in the KIT before starting the job.

We recommend using a lift while installing the Kit.

Protect and clean any mounting surfaces on your vehicle.

For the installation of this product at least two people are needed (mainly for holding the splitter on the car while drilling holes and attaching the part to the vehicle with supplied hardware). ©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Preparation! The splitter consist of three parts. The center piece, the driver side piece and the passenger side piece. The parts have to be mounted separately.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Preparation!

In case of technical questions contact us: Telephone:

561.845.7888

E-Mail:

[email protected]

Office Hours:

Mon-Fri: 8:30AM – 5:30PM EST Sat-Sun: By appointment only

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Part List

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Part List 218 CLS – 63 AMG – Front Splitter

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Part List 218 CLS – 63 AMG – Front Splitter Description

Quantity

Carbon Fiber Front Splitter (3 pieces)

1

Adhesion Promoter

2

Mounting screws w/ washers, self tapping

8

QC1

Signature:

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

QC2

Instructions

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter Removal of OE chin splitter and underbody panel fasteners 1. Start by removing the necessary underbody fasteners. 2. Take off two of the under body panel screws. One screw per side of vehicle (left hand side screw shown below)

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 3.

Remove the two, lower outer front fascia plastic clips. (left hand side shown here)

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 4.

To detach the OE chin splitter from the front fascia, start by removing the four upper plastic mounting clips behind/through the grill. We recommend using a pry tool and needle nose pliers, along with a flashlight.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 5.

The four lower plastic clips also need to be removed in order to remove the OE chin splitter. These are shown removed in the image below.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 6.

Removal of one of the four lower OE chin splitter plastic clips shown here.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 7.

Remove OE chin splitter.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 8.

This image shows the OE chin splitter removed.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter Installation of new splitter center section 1. Place the center section of the new splitter onto the front fascia. The RENNtech center section utilizes same lower grille slots as OE chin splitter.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 2.

Push the four lower OE plastic clips into the mounting holes located in the bottom side of the RENNtech center section piece.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 3.

Put the four upper OE plastic clips through the grill into the holes located behind the grill to finish the fastening of the center section piece on the car. *make sure the plastic clips are pressed in all the way and fully secure

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter Installation of the left side splitter section 1. Test fit the left side splitter section onto the fascia to ensure proper fitment.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 2. 3.

There should be a 3-4mm gap between the side piece and the center section of the splitter. The edge of the fascia/grille opening should align with the edge of the side piece.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 4. 5.

While holding the driver side part in the correct “installed” position on the car. Mark the fascia through bottom side mounting holes. These marks will be used for drilling the fascia, for mounting screws

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 7.

Carefully drill holes into fascia at your (white) marked locations.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 8. 9.

Hold the left side splitter piece up to the fascia. Create a tape line on the fascia just above the side splitter piece.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 10. Remove the side splitter piece. 11. Apply adhesion promoter to the fascia surface just below the tape line. The promoter solution will help attach the splitter section to the fascia surface.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 12. Hand tighten the OE underbody panel screw, which the side splitter utilizes for lower attachment. 13. The screw has to be loose so that the positioning of the side splitter piece is maneuverable for the following steps.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 14. Hold the left side splitter section in correct position on the fascia and slowly pull off the red tape backing. 15. Make sure to apply even pressure onto the side splitter section while pulling off the red tape backing.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 16. Push the lower/outer black plastic OE clip back in, over the side splitter piece.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 17. To finalize installation of the side splitter section, drill the supplied mounting screws into the lower fascia.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter Installation of the right side splitter section To mount the right side splitter section, please follow the same steps as mounting the left side splitter section. See pages 20-29.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Instructions 218 CLS – 63 AMG – Front Splitter 3-piece front splitter installation is now complete.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Check List! Ensure that all components are mounted correct.

Splitter pieces should not get wet within 24 hours of installation so that the 3M adhesive and promoter have enough time to set and cure onto the vehicle.

©RENNtech, Inc. - 1369 N Killian DR - Lake Park, FL 33403 - Tel: 561.845.7888 - Fax: 561.845.6777 visit us at www.renntechmercedes.com

Enjoy…!!!

RENNtech Inc. 1369 N Killian DR Lake Park, FL 33403 Tel: 561.845.7888 Fax: 561.845.6777 [email protected] www.renntechmercedes.com Office Hours Mon-Fri: 8:30AM-5:30PM EST Sat-Sun: By appointment only

Subject to change at any time without prior notice. © 2011 by RENNtech Inc.

Suggest Documents