Canolux LED

Petrol Station Forecourt Luminaires

Point source LEDs provide excellent opportunities to direct light accurately improving uniformity and reducing the electrical load. Well designed and manufactured optical components can provide the desired light distribution and lit appearance whilst limiting glare and providing optimum energy efficiency. Canolux LED technology can be combined with Smart External intelligent controls to provide a low maintenance, low energy fit and forget solution for lighting garage forecourts.

2

Contents Canolux LED Range

4

Programmability Scenarios

Full Specification

6

Programmable Features 16

Smart External

8

Dimensions 17

Motionline Scenarios

10

10 Year Life Costing Analysis 18

Smart Booster

12

HID vs LED Comparison 19

Motionline Linking

13

3

14

Recessed n

15 high power white LEDs

Photometric Guide

n

Fully electronic LED drivers

n

Clear acrylic front cover

Canolux LED 116W LED

n

Recessed or surface mounting options

n

Can replace existing Canolux HIT luminaires

n

Optional fully integral Smart External Micro-pod Sensor for automatic switching, dimming, presence detection and daylight sensing (see page 8 for details)



TRANSVERSE

AXIAL

100 200 300 400 Luminaire Lumen Output 116W = 13730lm

4

CANDELAS PER 1000 LUMENS

Surface IP43



Range

DESCRIPTION CAT. No. Recessed Standard CX 14641L Smart External CX 14642D Surface Mounted Standard CX 14643L Smart External CX 14644D

For dimensions and fixings (see page 17) for details.

LED CHARACTERISTICS Ra °K L70/B10 P/U % R/Rx PF LL/CW 70+ 4000 60K P >90 R >0.95 107.3

For LED characteristics explanation see www.thorlux.com/led-characteristics

APPROX. kg 13.0 13.1 8.7 8.8

CIRCUIT TYPE - L - non-dimming (LED) Smart External versions use digital dimming gear and are always suffixed D 5

Specification Body Zinc coated steel body with white full polyester powder finish, black anodised aluminium rear heat sink for LED cooling.

Heat Sink

Cover 3mm thick clear acrylic. LED Driver High quality electronic drivers, mounted in dedicated cool gear compartments.

6

Standards Complies with BS EN 60598 2-1, Classified IP43, CE Marked.

Smart System Electronic dimmable LED drivers are automatically controlled by the dedicated Smart External Micro-pod Sensor allowing instant switching and dimming of individual and / or groups of luminaires (see page 8 for details).

Voltage 220-240V, 50-60Hz, other voltages on request. LEDs High quality, high flux, >60,000hr rated life, 4000k, 70+ Ra LEDs mounted on a replaceable LED board. Other colour options available.

Smart External Micro-pod Sensor 7

Presence Detection

Traditionally, spaces such as petrol station forecourts remain lit all night (and often all day) even when occupancy is low. The Smart External Micro-pod Sensor built into each Canolux LED luminaire allows the luminaires to be switched off or dimmed down to a low output level when the area is unoccupied. As soon as the sensor detects movement, the luminaire will return back to full output. Presence detection parameters can be adjusted using a hand-held infra-red Smart External Programmer (see pages 14-15).

Canolux LED Smart External The world’s ever increasing demand for energy is rapidly changing our environment and the need for energy efficiency in every aspect of our daily lives has never been greater.

Combining programmable presence detection and light sensing with seven day programmable switching schedules massive, energy savings and extended maintenance cycles are possible.

“Smart External” is the latest addition to the Thorlux range of control systems bringing intelligent lighting control to a new range of exterior LED based luminaires.

Truly fit and forget lighting.

8

Ambient Light Control

The Smart External Micro-pod Sensor incorporates an ambient light sensor which will enable at dusk and disable at dawn. Ambient light level switching can be adjusted using a hand-held infra-red Smart External Programmer (see pages 14-15).

ENERGY SAVE MONEY SAVE THE ENVIRONMENT SAVE

9

Motionline Scenarios (Platforms 2 & 3)

Master Motionline

Motionline 1

Motionline 2

PLATFORM 3 : TIME AND WEB BASED CONTROL Offers time schedule control, so that luminaires may be switched off when not needed (can be remotely configured through a secure web-site). It also allows local configuration and manual override (Smart External Controller required).

The Smart External system can operate at three different levels (platforms) offering increasing functionality. PLATFORM 1 : STAND-ALONE The simplest level. Each luminaire operates as a stand-alone item. PLATFORM 2 : MOTIONLINE LINKED Groups of luminaires are linked with a two-core bus, called the Motionline, allowing each luminaire to pass presence detection to all luminaires within the group (see diagram above).

10

DESCRIPTION CAT. No. Smart External Controller

11

SC 14478

APPROX. kg 1.4

Smart Booster

The addition of a Smart External Booster allows other lighting such as signage and LED feature lighting to be switched from the canopy Smart luminaire’s PIR detector (PLATFORM 2 & 3) and via time control (PLATFORM 3).

DESCRIPTION CAT. No. Smart External Booster

SC 14430

APPROX. kg 0.9

For dimensions and fixings (see page 17) for details.

The Smart External Booster also allows up to 4 motionline groups to communicate with each other (see diagram on page 13).

12

Motionline Linking Max. 50 ballasts, Max. 50 ballasts, 500 metres 500 metres

Max. 50 ballasts, Max. 50 ballasts, 500 metres 500 metres

SEC SEC

M1 M1

Max. 50 ballasts, Max. 50 ballasts, 500 metres 500 metres

MM MM

RS RS

SEB SEB DS DS

Max. 5A Max. 5A en Opn e Op

Max. 64 ballasts, Max. ballasts, 30064 metres 300 metres

M2 M2

CENTRAL MOTION CENTRAL MOTION

en Opn e p O

SEC SEC SEB SEB MM MM M1 M1 M2 M2 DS DS RS RS

Smart External Controller Smart External Controller Smart External Booster Smart External Booster Master Motionline Master Motionline Motionline 1 Motionline 1 Motionline 2 Motionline 2 Digitally Switched (DSI) Digitally Switched (DSI) Relay Switched Relay Switched

en Op n e p O

Canolux LED Canolux LED

13

Bulkhead/ Bulkhead/ Signage Signage

LED Feature LED Feature Luminaires Luminaires

Programmability Scenarios Zone 1 Zone 2 Zone 3 Zone 4

Luminaires can be individually programmed (see page 16) to dim or switch in areas of low occupancy or in daylight conditions (Smart External Programmer required).

The system allows re-programming at any time should the lighting emphasis need changing.

Forecourts can be set as required with an emphasis on the following scenarios (see diagram above): A : BEST APPEARANCE Realising energy savings whilst keeping an ‘open for business’ feel. B : MAXIMUM ENERGY SAVINGS for the lowest running costs.

14

Lighting Zone

A - BEST APPEARANCE

B - MAXIMUM ENERGY SAVING

ZONE 1

On at 30% output.

Switched off when daylight, on all night at 30% output.

ZONE 2

Switched off when sufficient daylight, on all night at full output.

Switched off when sufficient daylight, dims down to 30% 5 minutes after last detected movement.

ZONE 3

Switched off when sufficient daylight, at night dims to 30% 5 minutes after last detected movement. Stays at 30% until dawn, or next detected movement.

Switched off when sufficient daylight, dims down to 30% after 5 minutes, then switches off 10 minutes later if no further movement is detected.

ZONE 4

Switched off when sufficient daylight, at night dims to 30% 5 minutes after last detected movement. Stays at 30% until dawn, or next detected movement.

Switched off when sufficient daylight, dims down to 30% after 5 minutes, then switches off 10 minutes later if no further movement is detected.

MAIN ENTRANCE AND EXIT

SHOP ENTRANCE AND EXIT

MAIN RE-FUELING AREA

AIR/WATER PUMPS

These are only a few examples, the possibilities are numerous.

15

Programmable Features One of the key benefits of the Smart External system is the ability to program every luminaire differently. Each luminaire can be tailored to suit its own very specific local requirements.

n

The main programmable features are:



n



Security level (see also Security delay) - Can be set anywhere between minimum and maximum. Factory setting 30%.

n

PIR sensitivity - May be adjusted to suit conditions.

n

No presence delay - After a variable delay (30 seconds to 10 hours) the luminaires turn off or go to the Security Level. Factory setting - 5 minutes ➡ 30% ➡ continuous security level .



n

Lights on setting - Completely variable. Factory setting approximately 200lux.



n



DESCRIPTION CAT. No. Smart External Programmer

SC 14228

n



APPROX. kg 0.4

16

Min lamp - The minimum dim level of the lamps can beset. Factory setting 10%. Max lamp - The maximum lamp level can be set to tune the levels to local conditions. Factory setting 100%. Security delay - This allows an interim delay (30 seconds to 10 hours, or continuous) at Security level. For example, all luminaires around the forecourt may be set to switch off except for entrance/exit areas which will reduce to 50%, for a further 3 hours (assuming no presence detected) or whilst the forecourt is open. Alternatively as a security feature, perhaps 1 in 5 lights may be kept on continuously at any chosen level and only increase to full brilliance when a person or car enters the forecourt or space.

Dimensions 557

8

28 x 6.5mm dia. holes

91 99*

98

610

49

* Standard versions only

343

216

302

552

91

593

148

580

2 - 40 x 10mm slots

99*

Recessed 182

180

Surface 62

120 CRS.

165 CRS.

120 CRS.

167 CRS.

Smart Booster

Thorlux Lighting is a corporate member of the APEA (Association for Petroleum and Explosives Administration) which offers guidance in the design and build of Petrol Station Forecourts.

17

4 x 5mm dia. fixing holes under cover

4 x 5 x 9mm knock-out slots

10 Year Life Costing Analysis CAPITAL, WATTAGE ENERGY ENERGY ENERGY AND PER COST PER COST MAINTENANCE DESCRIPTION QUANTITY LUMINAIRE ANNUM (10 YEARS) COST (10 YEARS) Typical 250W MBI-T vs LED Typical 250W MBI-T

16

275 £4,625 £55,532 £76,694

Canolux 116W LED

12

128 £1,615 £19,385 £31,355

SAVING

-

147

£3,010

£36,147

£45,399

Typical 250W MBI-T vs LED Smart External Typical 250W MBI-T

16

275 £4,625 £55,532 £76,694

Canolux 116W LED Smart External

12

128 £779 £9,351 £17,455

SAVING - 147 £3,834 £46,033 £59,091

Design / Installation / Maintenance assumptions: 1.

Canopy size is 15m x 15m.

2.

Luminaires are mounted at 5m for a comparative scheme (16 x HID and 12 x LED).

3.

Comparison between 250W Metal Halide Canolux and Canolux LED or Canolux LED Smart External.

4.

24 Hour opening of forecourt (luminaires permanently on).

18

5.

Average power reduction due to dimming 30%, average power reduction due to lack of occupancy 30%.

6.

Electricity price 12p/kWh (10 year cost includes 4% annual increase year on year).

7.

Site distance is 50 miles from the service depot (for maintenance calculations).

8.

Maintenance team comprises 2 people, 1 vehicle and access equipment.

HID vs LED Comparison Canolux LED can be installed as a replacement for 250W metal halide luminaires reducing the number of luminaires required and will achieve acceptable illuminance at the pump.

TYPICAL 250W METAL HALIDE CANOLUX

CANOLUX LED

0.70

0.80

Average illuminance at floor

400 lux

364 lux

Average vertical illuminance at pump

140 lux

130 lux

20

21

4.56 kW

1.56 kW

FACTOR Maintenance factor *

Max GR (Glare) Maximum total energy load * The maintenance factor for the 250W metal halide is lower due to poorer lumen maintenance of the lamp.

Energy consumed (W)

Energy Consumption Analysis 120

The Canolux displays an almost linear response to energy saved and light produced during dimming. For Example, if lamps are running at 30% light output then 68% power saving is achieved.

80

40

0

100%

80%

60%

40%

Dim Level (%)

20%

0% (Off )

19

Designers, manufacturers and suppliers of professional lighting systems INDUSTRIAL LUMINAIRES COMMERCIAL LUMINAIRES FLOODLIGHTING LUMINAIRES ARCHITECTURAL LUMINAIRES CONTROLS AND SYSTEMS TUNNEL LIGHTING SYSTEMS

Merse Road North Moons Moat Redditch Worcestershire B98 9HH England Tel: + 44 (0)1527 583200 Fax: + 44 (0)1527 584177 e-mail: [email protected] Web: www.thorlux.com Direct UK Sales Line: 01527 583222 Thorlux Carbon Offsetting Project: www.thorlux.com/trees A DIVISION OF F.W. THORPE PLC The information given in this catalogue is typical and must not be interpreted as a guarantee of individual product performance and/or characteristics. We reserve the right to alter specifications and designs without prior notice. THORLUX is a Registered Trade Mark of F.W. Thorpe Plc. CANOLUX and SMART EXTERNAL are Trade Marks of F.W. Thorpe Plc. P.N. 2351C Dec. ‘14

ISO 9001

ISO 14001

FM 10913

EMS 532104

Quality Management

Environmental Management